EVK-M10
- Origin
- Collected automatically
- Source
- Manufacturer page (u-blox.com) +1 more
- Retrieved
- 25 Sept 2026
- Last checked
- 25 Sept 2026
- Report
- Report an error or request removal
The EVK‑M10 features a rugged metal housing measuring 105 × 64 × 26 mm with a 14‑pin front connector exposing all chip interface pins. It supports SPI or I²C communication to the embedded M10 GNSS chip and is powered via USB, while on‑board power‑consumption sensors enable real‑time monitoring through u‑center PC software.
Physical
- Dimensions
- 105 × 64 × 26 mm
Source
- Source
- Manufacturer page
- Retrieved
- 25 Sept 2026
- Last reviewed
- 26 Sept 2026
- Confidence
- Medium · 80%
Collected automatically from the source; not reviewed yet.
Communications
- Interfaces
- SPI, I2C
Source
- Source
- Manufacturer page
- Retrieved
- 25 Sept 2026
- Last reviewed
- 26 Sept 2026
- Confidence
- Medium · 75%
Collected automatically from the source; not reviewed yet.
General
- Power input
- USB
Values are normalised to SI-style units. Open a value's source marker for provenance and confidence. Additional specifications are shown as published by the source, without unit conversion. Spotted an error? Report it to us, tell the manufacturer or claim this listing.
- Software & SDKs
- u‑center PC software
Ask u-blox about EVK-M10
AHRS
The VectorNav IMU/AHRS supplies high‑rate, low‑noise inertial data for autonomous navigation in drones, missiles, and other platforms.
APNT
APNT solutions deliver resilient positioning, navigation, and timing in environments where GNSS signals are jammed, spoofed or unavailable, enabling mission-critical operations for defense, aerospace, and autonomous platforms.
Agam GNSS Base RTK
The Agam GNSS Base RTK is a UART‑based GPS/GNSS module featuring the u‑Blox ZED‑F9P receiver, designed for use as an RTK base or rover with multi‑constellation support and sub‑centimetre accuracy.
Agam GNSS01 CAN
The Agam GNSS01 CAN is a Made‑in‑India GPS/GNSS module built around the NEO‑M9N chipset, featuring an integrated IMU, barometer, magnetometer, safety switch and buzzer with a CAN interface for seamless integration into any CAN‑based autopilot.